ADVANTAGE™ HOLELESS – Single & Two Stage Jacks |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
TWIN JACK HOLELESS CAR TYPE SUMMARYThis design uses (2) jacks, one on each side of the car, positioned between the platform and the hoistway wall. Single stage jacks are used for low travel, typically on 2 stop cars up to 14 ft. Two stage jacks are used for travel up to 28 to 30 feet (typically 3 to 4 stops). ADVANTAGESThe jacks are located above ground, thereby eliminating the need to drill a jack hole and eliminating the risk of oil contamination. This car type will also accommodate low and high capacity cars. DISADVANTAGESTravel is typically restricted to a 2 to 4 stop application. Depending upon the travel, an extended overhead may be required to fit the jacks into the hoistway elevation. The hoistway width requirement may also be a little greater than an in-ground car type, for high capacity applications. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
LOW CAPACITY STANDARD DIMENSION & SPECIFICATION CHART
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
OVERHEAD REQUIRED QUICK CALCULATIONRegardless of what the travel is, the standard mimimum overhead is 12'-8". Consult your Alliance Elevator representative if your overhead is less than 12'-8". For every 1" of travel over 12'-0" either the overhead or the pit depth must be increased by a corresponding 1". |
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
MAXIMUM INSIDE NET PLATFORM AREASTo allow for variations in cab designs, an increase in the maximum inside net platform area not exceeding 5% shall be permitted for the various capacity loads. |
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
APPROXIMATE CLEAR INSIDE DIMENSIONS OF CAB
Width = Platform Width less 4"
Depth = Front & Rear Open
DBG (Distance Between Guides)=Platform Width plus 3 1/4" 15# rail depth= 3 & ½" |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
RAIL BRACKET FASTENING TO HOISTWAY WALLS |